![]() value 5 – Not intended to meet OBD II requirementsĬontinuously Monitored Systems Support/Status.value 1 – OBD II (California Air Resource Board).This is a 1-byte field that shows the OBD compliance level of a controller. If no DTCs have been previously active, this field should be set to zero. This is a 1-byte field that gives the number of previously active DTCs in a controller. The data range of this field is 0-240. If no DTC active in a specific controller, then this field shall be set to zero. This is a 1-byte field that gives the number of active DTCs present in a controller. The data range of this field is 0-240. The following data is sent in the DM5 message. This is not a periodic message and can be requested using request PGN 59904. This message shows the diagnostic readiness information of a system. Diagnostic Message 10 (DM10) Non-continuously Monitored System Test Identifiers Supportĭiagnostic Message 5 (DM5) Diagnostics Readiness 1ĭM5 message uses PGN 65230 (0xFECE).Diagnostic Message 8 (DM8) Test Results for Non-Continuously Monitored Systems. ![]() Diagnostic Message 7 (DM7) Command Non-Continuously Monitored Test.Diagnostic Message 6 (DM6) Continuously Monitored Systems Test Results.Non-continuously Monitored Systems Status. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |